Wika CEP1000 Manuel d'utilisateur télécharger pdf (Page 22)

22 WIKA operating instructions, model CEP1000

11570351.02 10/2010 GB/D/F/E/I

8. Faults / 9. Return and disposal

8. Faults

Indication Type of fault Measures

Battery is low, functioning is only

guaranteed for a short period of time

Insert new batteries

-OL

Reading is signicantly above or

below the measuring range

Test: if the measurement parameter

is within the approved measuring

range of the instrument?

No display or

undenable

characters, the

instrument does

not respond to

key press

Battery is dead. Insert new batteries

System error Turn o the CEP1000, wait for a

short period of time, switch on again

The CEP1000 is defective Send in for repair

CAUTION!

If faults cannot be eliminated by means of the measures listed above,

the instrument must be shut down immediately, and it must be ensured

that pressure and/or signal are no longer present, and it must be

prevented from being inadvertently put back into service.

In this case, contact the manufacturer.

If a return is needed, please follow the instructions given in chapter

"9.1 Return".

9. Return and disposal

WARNING!

Residual media in dismounted loop calibrator can result in a risk to

persons, the environment and equipment. Take sucient precautionary

measures.

9.1 Return

WARNING!

Strictly observe when shipping the instrument:

All instruments delivered to WIKA must be free from any kind of hazard-

ous substances (acids, bases, solutions, etc.).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 111 112

Pas de commentaire

Wika CEP1000 Manuel d'utilisateur Page 22