Wika CPC3000 Manuel d'utilisateur télécharger pdf (Page 34)

Pneumatic High-Speed Pressure Controller CPC3000

WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.134

11498171.01 08/2009 GB

[Preset Points] allows the operator to select the number of points that appear as steps.

For example: in "Figure - preset points" [5] is entered as the preset points value, this

automatically configures 5 points from 0 to 100 % of user defined range. It automatically

calculates the steps that populate the STEP keypad in the main menu.



7.8.3 SETUP Remote

Configuration of parameters associated with remote communication are set up in the

MAIN -> [SETUP] -> [REMOTE] screen. Detailed information on SETUP of Ethernet USB and

IEEE-488 are given in chapter 8. "Remote Operation".

The ethernet SETUP key opens a dialog box where host name, IP, netmask, gateway,

port, and client IP can be entered. There is also a check box that will activate (checked) or

deactivate (unchecked) Dynamic Host Configuration Protocol (DHCP). DHCP is a protocol

used by networked devices (clients) to obtain the parameters necessary for operation in an

Internet Protocol network. This protocol reduces system administration workload, allowing

devices to be added to the network with little or no manual configuration.



Figure - SETUP Remote

Figure - Preset Points

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Pas de commentaire

Wika CPC3000 Manuel d'utilisateur Page 34