Wika CEP3000 Manuel d'utilisateur télécharger pdf (Page 15)

15WIKA operating instructions, model CEP3000

14036068.02 08/2012 GB/D

5. Transport, packaging and storage

5.1 Transport

Check the hand-held temperature calibrator for any damage that may have been caused

by transport.

Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change

in installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:

■

Storage temperature: -40 ... +60 °C

■

Humidity: 0 ... 90 % relative humidity (non-condensing)

Avoid exposure to the following factors:

■

Direct sunlight or proximity to hot objects

■

Mechanical vibration, mechanical shock (putting it down hard)

■

Soot, vapour, dust and corrosive gases

■

Potentially explosive environments, ammable atmospheres

Store the hand-held temperature calibrator in its original packaging in a location that

fulls the conditions listed above. If the original packaging is not available, pack and

store the instrument as described below:

1. Wrap the instrument in an antistatic plastic lm.

2. Place the instrument, along with shock-absorbent material, in the packaging.

3. If stored for a prolonged period of time (more than 30 days), place a bag containing a

desiccant inside the packaging.

WARNING!

Before storing the instrument (following operation), remove any residual

media. This is of particular importance if the medium is hazardous to

health, e.g. caustic, toxic, carcinogenic, radioactive, etc.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Pas de commentaire

Wika CEP3000 Manuel d'utilisateur Page 15