Wika A2G-05 Manuel d'utilisateur télécharger pdf (Page 8)

WIKA operating instructions air2guide model A2G-05

40387565.02 10/2013 GB/D/F/E/I

5. Transport, packaging ... / 6. Commissioning, operation

5. Transport, packaging and storage

5.1 Transport

Check the pressure gauge for any damage that may have been caused

by transport. Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during trans-

port (e.g. change in installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage

Storage temperature: -30 ... +80 °C

Protect the instruments from moisture and dust.

6. Commissioning, operation

Installation and mechanical connection

In accordance with the general technical regulations for pressure

gauges (e.g. EN 837-2 "Selection and installation recommendations for

pressure gauges").

■

Process connection back mount (BM)

■

Protect measuring instruments from contamination, high temperature

changes and vibrations

■

air2guide Eco dierential pressure gauges are calibrated in vertical

position and should be installed in the same position to avoid loss of

class accuracy. If a dierent installation position is required please

specify when ordering. Gauges with high pressure ranges can

be installed in dierent non-vertical mounting position, by simply

adjusting the zero point.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Pas de commentaire

Wika A2G-05 Manuel d'utilisateur Page 8