
Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 45
11498171.01 08/2009 GB
Command Data Response/Function
IP? <sp>nnn.nnn.nnn.nnn<cr><lf> Returns the IP address of the instru-
ment.
Keylock Yes or No Locks or unlocks keyboard.
Keylock? <sp>(Yes or No)<cr><lf> Returns Yes or No.
List? <sp>Pri,X,X;Sec,X,X;Bar,1<cr><lf> Returns list of available turn-downs on
installed sensors in the active channel.
X will be non-existent if the turndown
isn’t available.
Listrange? PRI,1, min,max,2, min, max;SEC,1,
min,max,2, min,max,Bar,min,max
Returns the ranges of the installed
sensors for the active channel.
Localgravity Value in ft/s² Sets the local gravity in feet/sec².
Localgravity? <sp>n.nnnnne+nn<cr><lf> Returns the local gravity in feet/sec².
LowerLimit Value inside primary xducer Range
on turndown #1 in current units.
Sets the lower control limit for the
instrument.
LowerLimit? <sp>xxxxxxx<cr><lf> Returns the lower control limit for the
instrument in current units.
Measure None Instrument placed in Measure Mode.
Measure? <sp>(Yes or No)<cr><lf> Returns YES if instrument is in
measure, No if otherwise.
Netmask nnn.nnn.nnn.nnn Sets the Ethernet network mask.
Netmask? <sp>nnn.nnn.nnn.nnn<cr><lf> Returns the Ethernet network mask.
Outform 1 to 8 – see table below Sets the output format.
Outform? <sp>X<cr><lf> Returns the output format – see table
below
Peakmax? <sp>n.nnnnne+nn<cr><lf> Returns the maximum pressure since
peakreset was sent.
Peakmin? <sp>n.nnnnne+nn<cr><lf> Returns the minimum pressure since
peakreset was sent.
Peakreset None Resets the peak values.
Port nnnnnn Sets the Ethernet port of the instru-
ment
Port? <sp>nnnnn<cr><lf> Returns the Ethernet port of the instru-
ment
Ptype Absolute or Gauge Sets the instrument pressure type
– gauge only works if the optional
barometric sensor is installed
Ptype? <sp>CCCCC<cr><lf> Returns “Absolute” or “Gauge” for the
pressure type
RangeMax? <sp>XXXXXXX<cr><lf> Returns the maximum range of the
active transducer and turndown in the
current units.
RangeMin? <sp>XXXXXXX<cr><lf> Returns the minimum range of the
active transducer and turndown in the
current units.
Rate? <sp>XXXXXXX<cr><lf> Returns the rate reading of the instru-
ment in current units/second.
Commentaires sur ces manuels