Wika CPC6000 Manuel d'utilisateur télécharger pdf (Page 56)

Automated Pressure Calibrator

CPC 6000

56 Mensor/WIKA Operating Instructions - CPC 6000

94 Rsetpt? <sp>{value}<cr><lf> Returns the current rate setpoint of the active

channel in current units per second.

Sbaud {9600, 19200, 38400, 57600} Sets the serial baud rate.

96 Sbaud? <sp>{value}<cr><lf> Returns the serial baud rate.

Sdata {7 or 8} Sets the serial data bits.

98 Sdata? <sp>{value}<cr><lf> Returns the serial data bits number.

99 Sensor C, X Sets the active sensor where C = Primary or

Secondary and X is the turndown.

100 Sensor? <sp>{C,X}<cr><lf> Returns the active sensor as above.

101 Sensor.acc? <sp>{value}<cr><lf> Returns the accuracy of the sensor.

102

Sensorid? <sp>{Address}<sp>MENSOR

,<sp>600SNSR,<sp>{Serial

No.},V{V.VV}<cr><lf>

Returns the active sensor’s serial number and

firmware version.

103

Setpt {A value inside the upper/low-

er limits, and inside the range

of the active transducer and

turndown}

Sets the control setpoint for the active channel.

104

Setpt? <sp>{value}<cr><lf> Returns the control setpoint of the active chan-

nel in current units.

105

Span {desired pressure or ?} Sets span on active transducer (must be >50%

FS, and within 1% limit), or ? to clear previous

value. (See “Caldisable” command above ref#

19)

106 Span? <sp>{value}<cr><lf> Returns span scale factor for active transducer

and turndown.

107

Sparity {Even, ODD , NONE} Sets the serial parity.

108 Sparity? {<sp>{string}<cr><lf> Returns the serial parity.

109 Srqmask Stable, Error or both Sets the CPC 6000 to issue a service request

(SRQ) over the IEEE-488 when the pressure

control is stable, or an error occurs. These are

80 hex and 40 hex respectively.

110 Srqmask? <sp>{string}<cr><lf> Returns “stable”, “error” or “error, stable” de-

pending on the SRQ.

111 Sstop {1 or 2} Sets the serial stop bits.

112

Sstop? <sp>{value}<cr><lf> Returns the serial stop bits.

113

Stable? <sp>{Yes or No}<cr><lf> Returns YES if instrument is stable or NO.

114

Stabledelay {0 to 65535} Sets the stable time to the number of seconds

specified.

115

Stabledelay? <sp>{value}<cr><lf> Returns the stable time.

116 Stabletime {0 to 65535} Sets the stable time to the number of seconds

specified.

117

Stabletime? <sp>{value}<cr><lf> Returns the stable time.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Wika CPC6000 Manuel d'utilisateur Page 56

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Wika CPC6000