Wika CPH65I0 Manuel d'utilisateur télécharger pdf (Page 20)

20 WIKA operating instructions, model CPH65I0

14061681.02 03/2013 GB/D

5. Transport, packaging and storage

5.1 Transport

Check hand-held pressure calibrator for any damage that may have been caused by

transport.

Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change

in installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:

■

Storage temperature: -20 ... +60 °C

■

Relative humidity: 5 ... 95 % r. h. (non-condensing)

Avoid exposure to the following factors:

■

Direct sunlight or proximity to hot objects

■

Mechanical vibration, mechanical shock (putting it down hard)

■

Soot, vapour, dust and corrosive gases

Store the hand-held pressure calibrator in its original packaging in a location that fulls

the conditions listed above. If the original packaging is not available, pack and store the

instrument as described below:

1. Wrap the instrument in an antistatic plastic lm.

2. Place the instrument, along with shock-absorbent material, in the packaging.

WARNING!

Before storing the instrument (following operation), remove any residual

media. This is of particular importance if the medium is hazardous to

health, e.g. caustic, toxic, carcinogenic, radioactive, etc.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Pas de commentaire

Wika CPH65I0 Manuel d'utilisateur Page 20