Wika CPH65I0 Manuel d'utilisateur télécharger pdf (Page 36)

36 WIKA operating instructions, model CPH65I0

14061681.02 03/2013 GB/D

6. Commissioning, operation

6.9 Measuring temperature with a resistance thermometer

For temperature measurement, select the function "RTD" on one of the displays.

The correct resistance thermometer must be used. There are four types of resistance

thermometer supported: "P100-385", "P100-392", "P100-JIS" and "CUSTOM".

The factory default type is "P100-385", so if the CPH65I0 is being used

with a WIKA Pt100 you do not have to reset the resistance thermometer

type.

The WIKA Pt100 needs only to be connected to the CPH65I0 and the measured

temperature will immediately be displayed.

The display will indicate "OL" if the measured temperature is outside

the nominal measurement range of the resistance thermometer (below

-40 °C or above +150 °C).

CAUTION!

Only specic thermometer types are permitted (as dened in

chapter 2.3). It is recommended that those accessories available from

WIKA are used.

Figure 3: CPH65I0 with a resistance thermometer

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 99 100

Pas de commentaire

Wika CPH65I0 Manuel d'utilisateur Page 36