Wika Pascal ET Manuel d'utilisateur télécharger pdf (Page 48)

6 Commissioning, operation

48 WIKA Operating Instruction, Pascal ET and Pascal ET/IS

6.3.2.4 Temperature Simulation

The procedure for the temperature simulation assignment is similar to the measurement one as

described previously, except for the step “Select measure or simulation” where the operator needs

to press SIMULATION instead of MEASURE. In the following step the user needs to select one of

the output OUT A or OUT B available.

Figure 52 – Generation module selection

6.3.2.5 Electrical parameter generation

The procedure for the assignment of the generation of an electric parameter (for example mA) is

similar to the electrical signal measurement one as described previously, except for the step

"Select measure or generation” where the operator needs to select GENERATION instead of

MEASURE.

Then the user needs to select OUT A or OUT B (if available).

Figure 53 – mA generation module selection

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

Pas de commentaire

Wika Pascal ET Manuel d'utilisateur Page 48