Wika Pascal ET Manuel d'utilisateur télécharger pdf (Page 69)

6 Commissioning, operation

WIKA Operating Instruction, Model Pascal ET and Pascal ET/IS 69

Once all parameters are set, press ON to enable the function: on the main display SCL writing will

appear. The new value will be displayed with the new engeneering unit in big letters. The existing

measurement will be displayed below in small letters. Example available here below:

Figure 79 – Channel with Scaling enabled

6.5.4 Filter

The FILTER can filter a measurement.

Press FILTER to visualize: “Filter parameter setting”

Filter can be set through the following:

Filter weight: in percentage

Select the filter weight and then press ON.

FLT writing will be displayed when filter is active. Filtered value will be displayed in big letters, real

value will be displayed below in small letters.

6.5.5 Hold On – Hold Off

HOLD ON-HOLD OFF is used to freeze what displayed in a specific channel.

Press HOLD ON to hold the values: HOLD OFF will appear. Press it to unlock the channel. HOLD

ON will appear again

HLD on the display means that the values are hold. See below:

Figure 80 – Channel with HOLD enabled

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 87 88

Pas de commentaire

Wika Pascal ET Manuel d'utilisateur Page 69