Wika CPC6000 Manuel d'utilisateur télécharger pdf (Page 25)

Automated Pressure Calibrator

CPC 6000

Mensor/WIKA Operating Instructions - CPC 6000 25

5. Installation

5.1 Unpacking the System

In addition to this manual you should have:

CPC 6000 Automated Pressure Calibrator

Power cord

1/8 inch FNPT fitting adapters fastened to rear panel

Any accessories ordered

An envelope containing the Calibration Certificate

Your new instrument was subjected to many hours of functional testing before it left the factory. In

addition to testing, the unit was inspected for appearance prior to being packaged for shipment. Upon

removal from its carton please examine the instrument for shipping damage. Report any apparent

damage to the carrier immediately.

5.2 Dimensions

Figure 5.2 - Dimensions

5.3 Mounting

The instrument can be set up on a table top or it can be rack-mounted. Rack mount adapters are

optional on the CPC 6000 and require an adapter panel (see “

8.2 - Rack Mount Kit” in Section 8,

Options). The special sensors used in the CPC 6000 are relatively insensitive to tilt and vibration.

However to further assure stability and accuracy, avoid mounting the instrument on surfaces subject

to excessive motor or machinery vibration.

■

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 103 104

Pas de commentaire

Wika CPC6000 Manuel d'utilisateur Page 25