Wika CPC6000 Manuel d'utilisateur télécharger pdf (Page 45)

Automated Pressure Calibrator

CPC 6000

Mensor/WIKA Operating Instructions - CPC 6000 45

7. Remote Operation

7.1 Remote Setup

Use the following screens to set the operating parameters for the Ethernet, RS-232 serial port, and

IEEE-488.

Press the [Remote] key located on the bottom left corner of the screen, and a new display appears

with another set of tabs across the top as shown in Figure 7.1.1.

7.1.1 [Instrument] Setup Screen

Press the [Instrument] tab to set up available emulation modes. The default command set is Mensor.

Figure 7.1.1A - [Instrument] Setup Screen

[A] [B] (channel selection): This channel selection sets the active remote channel to A or B and is

useful for customers using an CPC 6000 to replace two single channel controllers. The user can simply

select the channel here first and then begin their normal program.

[Monitor] key: Press the [Monitor] key to bring up the remote monitor window which displays current

remote activity and syntax errors. This is helpful when troubleshooting programs.

Figure 7.1.1B - Monitor Window

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 103 104

Pas de commentaire

Wika CPC6000 Manuel d'utilisateur Page 45