Wika CPC2000 Manuel d'utilisateur télécharger pdf (Page 16)

16 WIKA operating instructions, model CPC2000

11155094.02 07/2012 GB/D/F/E

5. Transport, packaging and storage

5.1 Transport

Check low-pressure controller for any damage that may have been caused by transport.

Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change in

installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:

■

Storage temperature: -10 ... +70 °C

■

Humidity: 30 ... 80 % r. h. (no condensation)

Avoid exposure to the following factors:

■

Direct sunlight or proximity to hot objects

■

Mechanical vibration, mechanical shock (putting it down hard)

■

Soot, vapour, dust and corrosive gases

■

Potentially explosive environments, ammable atmospheres

Store the low-pressure controller in its original packaging in a location that fulls the

conditions listed above. If the original packaging is not available, pack and store the

instrument as described below:

1. Wrap the instrument in an antistatic plastic lm.

2. Place the instrument, along with shock-absorbent material, in the packaging.

3. If stored for a prolonged period of time (more than 30 days), place a bag, containing a

desiccant, inside the packaging.

4. Do not storage the instrument with the pressure connections closed! Barometric

pressure changes can damage instruments with low pressure ranges.

WARNING!

Before storing the instrument (following operation), remove any residual

media. This is of particular importance if the medium is hazardous to

health, e.g. caustic, toxic, carcinogenic, radioactive, etc..

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 131 132

Pas de commentaire

Wika CPC2000 Manuel d'utilisateur Page 16