Wika CPC2000 Manuel d'utilisateur télécharger pdf (Page 21)

21WIKA operating instructions, model CPC2000

11155094.02 07/2012 GB/D/F/E

6. Commissioning, operation

The gure shows the ow chart for the AUTO mode. Based on the table, one will know

which cycles are being carried out and the meaning of each.

Setting

■

CYCLES: Here the number of cycles to be carried out in AUTO mode will be set.

■

T START: Delay time to vent the sensor

■

T STOP: Delay time before reaching the maximum dened pressure

■

T HOLD: Hold time until a new pressure value is reached

■

T PAUSE: Delay time between two cycles

■

AUTO ZERO: Automatic zero point adjustment at the completion of each cycle

To exit the submenu, press the MENU button.

Operation

On leaving the menu, the calibrator will revert to 'Standby status'. All information about the

AUTO mode will be shown on the display.

Operating mode

First of ten cycles Phase 1: It has been

vented (Pressure = 0)

percentage display of the current set

pressure

Pressure unit

Set pressure

Start

1 2 4 5 7 9 10 9 10 9 10 9 10 13 15 16 15 16 15 16 15 16 18

Next cycle

End of cycle

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 131 132

Pas de commentaire

Wika CPC2000 Manuel d'utilisateur Page 21