Wika CPC2000 Manuel d'utilisateur télécharger pdf (Page 20)

20 WIKA operating instructions, model CPC2000

11155094.02 07/2012 GB/D/F/E

6. Commissioning, operation

6.3 Operating mode 'AUTO'

AUTO

mode, a pressure prole can be stored. This is especially useful when multiple

pressure sensors or pressure switches are to be calibrated with the same values. The

mode also enables a dened prole to be traversed several times in succession.

Setting

■

Press the MENU button. Conrm the menu item MODE with the SELECT button and

press the

/ button until AUTO appears. Conrm with SELECT.

■

For the AUTO mode, the submenu points RANGE, UNIT and STEPS are not relevant.

■

Go to the SETTINGS menu item with the / buttons and conrm with the

SELECT button. The submenu item zero point adjustment is not relevant.

■

In the submenu, go to the AUTO mode item with the UP/DOWN buttons and conrm

with SELECT.

■

RANGE: Pressure range that will be covered

■

UNIT: Pressure unit

■

STEPS

: The number of steps which will be taken to increase and decrease the

pressure. These increments are calculated by the controller itself.

In the submenu point, CONFIGURATION 1, further settings can be dened for the

AUTO

mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 131 132

Pas de commentaire

Wika CPC2000 Manuel d'utilisateur Page 20